Plastisol ink from the AMEX PLAST PF range, opaque with a glossy finish, for textile screen printing.
Features
- High opacity
- Good wet-on-wet printability
- High colour brightness
- Good elasticity
- Phthalate free
Preparation
Ready to use – stir well before printing. All colours in the range can be mixed with each other in any ratio; do not mix more than three bases at a time. For a more matt result and a softer hand add up to 60% PLAST PF TRASPARENTE.
Printing and curing
Set off-contact and squeegee pressure carefully for best opacity and shade. Recommended emulsion: SCREEN-SOL QT BLU. Cure at 150–160 °C for 2–3 minutes. Always check curing conditions: only a fully fused film delivers the final properties.
Cleaning
Clean tools with SOLVENTE 105.
Note: plastisol inks do not withstand dry cleaning or direct ironing.
This shade
Grey barrier underbase, used on polyester and synthetic garments to help block dye migration into the top colours.
Safety
Wear gloves when handling and cleaning up with solvent. Work in a ventilated area.
